Publicidad
Idiomas disponibles
Idiomas disponibles
DO NOT mount the splitter device at the back of the Remote Inter-
face Controller or to the back of the remote sensor as this WILL
cause equipment failure.
NOTE: Wine Guardian unit has an internal trap. Do not double trap
piping. Failure to comply may lead to water leaks and possible wa-
ter damage to surrounding mounting area. Install drain line with a
¼ inch per linear foot (1.25 cm/linear meter) of pitch.
3. Wiring Thermostat—continued
E. Drill two 1/8" (3 mm) holes and insert anchors
within mounting surface. Anchors may not be re-
quired if securing to wall studs or racking.
F. Provide 1¼" (32 mm) diameter hole within wall
or rack ng structure to provide clearance for RJ14
connection at back of controller.
G. Connect cable to the back of the remote user
interface and attach backing plate to wall using two
screws supplied with remote user interface.
H. Re-attach front cover plate by snapping it into place
on the back plate.
I. Reconnect cable to side of Wine Guardian unit at
either COMM1 or COMM2.
NOTE: Splitter devices (if being used for multiple
sensors) must be mounted at the WG unit.
4. Condensate Drain
A. Wine Guardian ducted systems are supplied
with 7 feet (2 meters) of ½" (13 mm) inside dimension
clear tube.
B. Connect clear plastic tube to barbed fitting at
unit and route to nearest open floor drain, sink or con-
densate pump.
5. Installing Ductwork
A. Wine Guardian unit is supplied with one (1)
supply duct collar and (1) return duct collar as stand-
ard equipment.
B. Install ductwork by folding back the insulation
to expose the wire reinforced vinyl duct.
4
Publicidad
