Mounting Bracket - BIG ASS FANS i Serie Guia De Instalacion

Make sure power is disconnected from the fan location before installing the mounting plate or
!

mounting bracket!

Low Profile Mount
Drill four Ø 8 mm holes in the pattern shown. The hole depth should not exceed 46 mm.
Remove any dust from the holes. Insert four anchor bolts (a) into the holes. Strike the heads of the anchor bolts with a hammer, ensuring the bolt
sleeves are flush with the ceiling surface.
Position the mounting plate (b) on the anchor bolts. Ensure all four anchor bolts are fully tightened to expand and lock the anchors.
If required by local building and safety codes, install an anchor hook (c) for the safety cable. Drill an Ø 8 mm hole for the anchor hook in the
pattern shown. The hole depth should not exceed 46 mm. Remove any dust from the hole, and then insert the anchor hook and fully tighten.
Standard Mount
Drill four Ø 8 mm holes in the pattern shown. The hole depth should not exceed 46 mm.
Remove any dust from the holes. Insert four anchor bolts (a) into the holes. Strike the heads of the anchor bolts with a hammer, ensuring the bolt
sleeves are flush with the ceiling surface.
Position the hanger plate (b) on the anchor bolts. Ensure all four anchor bolts are fully tightened to expand and lock the anchors.
If required by local building and safety codes, install an anchor hook (c) for the safety cable. Drill an Ø 8 mm hole for the anchor hook adjacent to
the hanger plate. The hole depth should not exceed 46 mm. Remove any dust from the hole, and then insert the anchor hook and fully tighten.
Universal Mount
Drill three Ø 8 mm holes in the pattern shown. The hole depth should not exceed 46 mm.
Remove any dust from the holes. Insert three anchor bolts (a) into the holes. Strike the heads of the anchor bolts with a hammer, ensuring the
bolt sleeves are flush with the ceiling surface.
Position the mounting bracket (b) on the anchor bolts. Ensure all three anchor bolts are fully tightened to expand and lock the anchors.
If required by local building and safety codes, install an anchor hook (c) for the safety cable. Drill an Ø 8 mm hole for the anchor hook. The hole
depth should not exceed 46 mm. Remove any dust from the hole, and then insert the anchor hook and fully tighten.
HAIKU ® BY BIG ASS FANS
15