Harmonics Selection; Operating Limits - Circutor AFQm IP54 Serie Manual De Instrucciones

7.5.- HARMONICS SELECTION

Note: This screen is not visible on the "slave" devices.
Note: The screen that appears if you have selected the operating mode FREQ: Frequency mode
WORKING MODE")
The harmonics to be filtered are selected in this screen,
Press the

7.6.- OPERATING LIMITS

Note: This screen is not visible on the "slave" devices.
In this screen,
● Min current
The minimum load current to start the active filter is configured with this parameter. Minimum current
feature is used to increase the system efficiency, by stopping the filter when required. The AFQm IP54
will stop when the load current is below the entered value and will start when it is higher.
144
Figure 59: Configuration screen: Harmonic selection.
key to save the modified settings.
, the operating limits of the device are configured:
Figure 60
Figure 60: Configuration screen: Operating limits.
.
Figure 59
AFQm IP54
("7.4.-
Instruction Manual