Circutor AFQm IP54 Serie Manual De Instrucciones página 158

Parameter
Initial Conditions for which the device does not start up.
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
(6)
Parameter
AFQm IP54 status
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
(7)
158
Table 29 (Cont.): Modbus memory map: Filter messages (Table 2).
Bit
0x00000008
0x00000010
0x00000020
0x00000040
0x00004000
0x00008000
0x00010000
0x00020000
0x00100000
0x00200000
Table 30: Modbus memory map: Filter messages (Table 3).
Bit
0x0001
0x0002
0x0004
0x0008
0x0010
0x0020
0x0040
0x0080
0x0100
0x0200
0x0400
Table 31: Modbus memory map: Filter messages (Table 4).
(7)
Status (Decimal value)
0
10, 20, 30
40
50
60
100
200
300
400
500
600
666
700
Description
L3 overcurrent alarm
L1 overvoltage alarm
L2 overvoltage alarm
L3 overvoltage alarm
Temperature IGBT 1 alarm
Temperature Inductor 1 alarm
Initial Conditions Error
Resonance Alarm
Contactor faults
Temperature Inductor 2 alarm
(6)
Discharging DC bus
Minimum Mains Voltage
Minimum temperature value
Frequency error
Charging DC bus
Minimum DC bus voltage
DC Bus imbalance
The device does not communicate
Polarity Error
Minimum load current
Maximum charge current
Address
104
Description
Start-up
Calibration
Relay test
Expect communications
Configuration
Start
Initial conditions
Stop
Synchronising
DC bus load
Operation
Power off
Alarm
AFQm IP54
Address
108
Description
Instruction Manual