Courtesy Lights - V2 City4 Manual De Instrucciones

tiM TIMER the relay closes when a remote control arrives on channel 4 and opens after the set time
biSt BISTABLE the relay changes each time a remote control arrives on channel 4
Mon MONOSTABLE the relay keeps closed until a signal given by the remote control on channel 4 arrives.
Blinker during pause time
Blinker usually operates during the gate motion only; however, if this
function is enabled, blinker will be on during the pause time too.
Start input function
This menu allows selecting input operation modes (see paragraph
"Activation inputs"):
StAn Start and Pedestrian Start input standard operation,
according to menu setups.
no Start inputs from terminal board are disabled. Radio inputs
operate in StAn mode.
AP.CH Start impulse always controls the opening phase, Pedestrian
Start always controls the closing phase.
PrES Manned operation; the gate will open as long as the Start
input stays closed and it will close as long as Pedestrian
Start stays closed.
oroL Timer-operation; the gate stays open while the Start input or
Pedestrian Start input is closed; as soon as the contact
opens, the pause count down will start.
32

Courtesy lights

Thanks to the output COURTESY LIGHT
the control unit City4 allows the
connection of an electric appliance (e.g.
courtesy light or garden lights), controlled
automatically or by means of the special
transmitter key.
t.LUC the relay closes when a start or a
pedestrian start control is given
and opens after the set time. It
works in the same way whit a
remote control on channel 4.
CiCL the relay keeps closed during the
whole opening/closing phase. In
case of intervention of a remote
control on channel 4, it keeps
closed for the time set by item
T.LUC
AUS auxiliary output with settable
operation logic
In this last case, the COURTESY LIGHT
output becomes an auxiliary output to
which it is possible to link one of the
following operation logics: