Preparation Of The Coating Material; Start-Up - WAGNER WallPerfect FLEXIO 580 I-Spray Manual De Usuario

GB
Pay attention to the quality of the adhesive tape used.
i
Do not use excessively strong adhesive tape on wallpaper and painted
surfaces, in order to avoid damaging these surfaces when removing the
tape. Remove adhesive tape slowly and evenly; do not use jerky movements.
Do not leave adhesive tape on surfaces any longer than necessary, in order
to minimise the possibility of residues when removing.
Also observe the adhesive tape manufacturer's instructions.

9. preparation of the Coating Material

•
M ix the material well in the original container. When using interior wall paint, an
agitator is recommended.
Flexio 580 has been developed for use with all conventional paints in their
i
undiluted form. If the surface is smooth and the paint you are using is very thick
and gel-like, dilute it by 10%. Dilution can be necessary if the atomisation is
coarse or if the flow rate is too low even at the maximum setting.
Detailed information about the various materials and the maximum permitted
dilution can be found on the manufacturers' technical data sheets (e.g. available
on the Internet).
Spray material that is at least at room temperature provides a better spray
i
result.

10. start-up

Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
•
U nscrew the container from the spray gun.
•
A ligning suction tube. (Fig. 2)
If the suction tube is positioned correctly, the container contents can be sprayed without
almost any residue.
When working on lying objects: Turn the suction tube forwards. (Fig. 2 A)
Spraying work when working on overhead objects: Turn the suction tube rearwards.
(Fig. 2 B)
•
P lace the container on a paper base and pour in the prepared coating substance with the
aid of the feed hopper included in the scope of supply (Fig. 1, 16). Screw the container
tightly onto the spray gun.
•
C onnect the front part with the rear part of the gun (Fig. 3).
•
P ut the machine down only on a level, clean surface. Otherwise the machine could tip
over!
•
P ull the trigger. The Flexio 580 has a two-stage trigger. In the first stage the turbine is
started. If the trigger guard is pressed further, the material is transported.
46
Flexio 580 I-Spray