WAGNER WallPerfect FLEXIO 580 I-Spray Manual De Usuario página 62

GB
problem
Coating material
drips from the
nozzle
Atomisation too
coarse
Spray jet pulsates
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)
Paint in the
ventilating hose
Poor covering
capacity on the wall
54
Cause
•
N ozzle loose
•
N ozzle worn
•
N ozzle seal is missing or worn
•
C oating material assembly at air
cap, nozzle or needle
•
C oating material too thick
•
M aterial volume too large
Material volume adjusting screw
turned too far to the right (+)
•
N ozzle contaminated
•
A ir filter heavily soiled
•
T oo little pressure build-up in
container
•
A mount of air too low
•
C oating material in container
running out
•
A ir filter heavily soiled
•
N ozzle seal is missing or worn
•
T oo much coating material
applied.
•
D istance to the object too large
•
T oo much coating material
applied
•
A mount of air too high
•
D iaphragm soiled
•
D iaphragm defective
•
S pray material is too cold
•
H ighly absorbent surface or paint
with poor covering capacity
•
D istance too large
Flexio 580 I-Spray
remedy
➞ Tighten
➞ Change
➞ Insert an intact nozzle
seal
➞ Clean
➞ Dilute
➞ Turn material volume
adjusting screw to the
left (-)
➞ Clean
➞ Change
➞ Tighten container
➞ Increase air quantity
(Level II)
➞ Refill
➞ Change
➞ Insert an intact nozzle
seal
➞ Turn material volume
adjusting screw to the
left (-)
➞ Reduce distance
➞ Turn material volume
adjusting screw to the
left (-)
➞ Decrease air quantity
(Level I)
➞ Clean the diaphragm
➞ Replace the diaphragm
➞ The material you are
spraying should be at
room temperature
➞ Cross spray (Fig. 11)
➞ Closer to the object