Monster Greenpower Plus Outlet Management Hook-Up; Greenpower Plus Factory Settings; Coaxial Connections Hook-Up - Monster Power HDP 1250G+ Manual De Instrucciones

ENGLISH
Hook-Up Guide
monster GreenPower Plus outlet management Hook-Up
™
GreenPower Plus Controlled (switched) outlets are designed
to automatically shut down when the component plugged into
the GreenPower Plus Control Outlet is turned off.
A Plug your HDTV/TV into the GreenPower Plus Control outlet.
B Plug other components into their corresponding GreenPower
Plus Controlled outlets.
C With your HDTV/TV in stand-by mode, press and hold down
the GreenPower Plus Programming button (labeled "Switched")
on the front panel for ten (10) seconds. The PowerCenter
will beep three (3) times to indicate it has learned the TV's
stand-by power draw.
GreenPower Plus GreenPower Plus
16
Control Outlet Controlled Outlets
When the HDTV/TV plugged into the GreenPower Plus Control
Outlet is turned off or goes into stand-by mode, the GreenPower
Plus Controlled Outlets automatically shut down, eliminating
wasted stand-by mode power consumption.
When you turn your TV back on, the GreenPower Plus outlets
automatically power up again.

GreenPower Plus factory Settings

Follow this procedure to return the PowerCenter to the original
factory settings for activating GreenPower Plus:
Press and hold Greenpower Plus Programming button for
fifteen (15) seconds or until PowerCenter beeps five (5) times
(Ignore the triple beep after five seconds).
Factory settings feature a Trigger ON at 15W
and a Trigger OFF at 10W.
GreenPower Plus
Programming Button
Hook-Up Guide

Coaxial Connections Hook-Up

Coaxial Connections provide surge protection against damaging
voltage surges and spikes on the incoming coax cable. The HDP
1250G+ Cable/TV coaxial connection also features ground loop
isolation to dramatically reduce unwanted noise.
ENGLISH
Protect TV/Cable and Satellite Connections as follows:
From properly From properly grounded
grounded Antenna Satellite Dish/Cable Line
To TV To Satellite Receiver/
TV/Cable Box
Notes: You may need additional coaxial cables to connect
the HDP 1250G+ to your components.
To ensure complete power surge protection, all lines that connect
to your AV components need to be connected to surge protected
connections on the PowerCenter.
17