Hook-Up Guide; High-Definition Digital Outlet Hook-Up; Monster Greenpower Plus Outlet Management Operation - Monster Power HDP 1250G+ Manual De Instrucciones

ENGLISH

Hook-Up Guide

High-definition digital outlet Hook-Up

These outlets have a special filter circuit that is optimized
to reduce interference to your high-definition digital components.
A Attach a Monster Power identification label to each
component's power cord before you plug it into
the appropriate color-coded PowerCenter outlet.
B Plug each component's power cord (HDTV, DVD, etc.) into
the PowerCenter's corresponding outlet. For components
not listed, determine if they are audio, video, high-definition
digital or ultra-high current audio components, and use
a corresponding outlet for best performance.
14
Important Note
It does not harm analog audio, video, or high current audio
components to be connected to the high-definition digital outlets.
However, for best performance, we recommend plugging in only
digital components to the high-definition digital outlets.
High Definition Digital Outlets
Hook-Up Guide
monster GreenPower Plus outlet management operation
™
Please Read These Instructions Before Connecting Any Equipment to the GreenPower Plus Controlled (Switched) Outlets.
1 Make sure that GreenPower Plus is enabled. Press and hold
down the Power button (labeled "Switched") on the front
panel for five (5) seconds. When the PowerCenter beeps
twice, GreenPower Plus is activated. When it beeps once,
GreenPower Plus is disabled.
2 You must connect an electronic device that draws sufficient
power in operational mode to activate GreenPower Plus
switched outlets. If you do not, the GreenPower Plus switched
outlets will not deliver power to connected equipment.
3 If you hook up a hard drive-based device such as a DVR,
cable/satellite box, or video game console to a GreenPower
Plus switched outlet, make sure that the device is not being
read from or written to when you turn off the component
connected to the GreenPower Plus Control outlet.
ENGLISH
Important data and settings stored on hard drives (recorded
TV shows, game saves, etc.) may be corrupted or deleted
if power is turned off while the hard drive is being read from
or written to. To ensure against the possibility of data loss
or corruption, you should connect hard drive-based devices
to unswitched outlets (or disable GreenPower Plus using
the switch located at the end of the PowerCenter). Monster
assumes no responsibility for data loss, corruption or damage
to hard drive-based devices connected to PowerCenters with
GreenPower Plus automatic outlet switching.
4 Some components can take up to 10 minutes to switch
to stand-by or sleep mode. If the Monster GreenPower
Plus switched outlets on your PowerCenter do not turn off
immediately, please wait approximately 10 minutes to allow
the component plugged into GreenPower Plus Control outlet
to switch to stand-by mode. When it is in stand-by mode,
hold down the Dimmer Control button on the front panel
down for five seconds. The PowerCenter will beep three times
to indicate it has learned the TV's stand-by power draw.
15