Monster Greenpower; Fireproof Mov Technology; Advanced Tri-Mode Surge Protection - Monster Power HDP 1250G+ Manual De Instrucciones

ENGLISH

monster Greenpower

Plus outlet management
™
GreenPower Plus is Monster Power's
latest breakthrough in energy savings.
Plug your HDTV in stand-by mode
into the control outlet, hold down
the programming button and the PowerCenter will "learn" your
TV's stand-by power draw. Anytime your TV is in stand-by mode,
fireproof moV Technology Protects your Equipment and your Home
Power surges can harm not only
your valuable home theater
equipment but can also start
a fire in your home—even
if you're using a surge protector. Ordinary surge protectors use
plastic-coated MOVs—metal oxide varistors—to absorb excess
voltage. But powerful surges can overheat and melt the plastic
coating, potentially causing a fire.
8
the other GreenPower Plus outlets will automatically switch
®
off to eliminate stand-by power waste by other equipment.
When you turn your TV back on, the GreenPower Plus outlets
automatically power up again.
This Monster PowerCenter features ceramic-encased MOVs
for superior fire protection. The ceramic enclosure is made
of the same fireproof material used on the space shuttle to give
you peace of mind that your home theater and, more importantly,
your home is safe.
Patented monster T2 Technology
™
The Monster HDP 1250G+
features exclusive Monster T2
™
technology. T2 is an active electronic
microprocessor-controlled circuit
that sits in front of the surge protection circuitry in select Monster
Power products. T2 monitors the line, neutral and ground lines
and automatically disconnects the PowerCenter from the AC
power line when a long duration low-voltage sag or high-voltage
swell occurs (continuous voltage below 80Vrms or above 132Vrms).
When the voltage sags or swells to these potentially damaging
levels, ultra-fast T2 auto-disconnect protection circuitry shuts down
Advanced Tri-mode Surge Protection
®
For added protection against
more powerful overloads, patented
Monster Tri-Mode automatically
disconnects your equipment
ENGLISH
the Monster PowerCenter for 15 seconds. When the under-voltage
or over-voltage condition returns to normal, T2 reconnects
the PowerCenter to the electricity and resets to full operation
after 15 seconds. If the power fault condition does not clear,
the T2 comparator circuit keeps the unit shut down.
Unlike ordinary power management devices, T2 will shut down
your PowerCenter before the MOVs (Metal Oxide Varistors)
and thermal fuses sense an overload condition and sacrifice
themselves to protect your connected components. This will
extend the PowerCenter's life, while providing the system
protection you need.
and sounds an alarm. Tri-Mode protects against surges and spikes
on all three power lines (line, neutral, and ground) for a triple layer
of safety. Only Tri-Mode offers this level of protection.
9