10- User Manual - Vimar Elvox ACTO 510A Manual Para El Conexionado Y El Uso

Actuador para cancelas correderas 230 vac
Ocultar thumbs Ver también para Elvox ACTO 510A:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 21
ACTO
User Manual
Safety Warnings:
Do not enter the automation system's range of movement while it is in motion; wait until all movement has stopped.
Only activate the automation system when it is completely visible and free from any obstacles.
Do not allow children or animals to play or sit near the range of movement. Do not allow children to play with the opening controls, or with the remote control.
Do not attempt to counteract automation system movement as this results in a dangerous situation.
Do not touch the equipment with wet hands and/or feet.
User Information:
-
Carefully read all enclosed instructions and documentation.
This product must be used exclusively as specified in design, any other use is to be considered improper and therefore hazardous
-
The information in this document and any attached paperwork may be subject to modification without notice. It is supplied as a guideline for product ap-
plication.
-
In case of a fault and/or poor operation of the automation, disconnect the system from the mains by means of the main switch and contact professionally
qualified personnel or an authorised service centre for assistance. Never attempt direct repairs or intervention.
-
Have the general operation of the automation system and the safety devices checked every six months by qualified personnel.
Emergency release in the event of a mains power failure (fig. A):
1- .Raise the lock cover and insert the release key.
2- .Turn the key fully clockwise.
3- ..Operate the release lever as shown in the figure.
We recommend that you move the gate into the completely open position (opening limit switch engaged) and reset the release to prevent unwanted move-
ment of the gate (with the gear motor released the gate is free to move and this could cause damage or injury).
Resetting the motor lock (Fig. B):
1- .With the actuator released, move the release lever into the rest position.
2- .Lock the lever in the rest position by closing the lock with the key
3- .Push the gate until you hear "clack", indicating that the motor is back in the locked position
CAUTION: Always perform the release and reset operation with the gate and the electric motor stopped!!!
1
2
12
2
1
A
B
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Elvox acto 810aEsm8Esm9

Tabla de contenido