RIB MASTER Wi-Fi FR Manual Del Usuario página 20

G
B
C
- LAYOUT
J8
J1
BUZZER
10 9 6 5
+ -
J1 => CONNECTOR FOR CONNECTIONS TO THE CONTROL PANEL
AND SAFETY INPUTS
Green wire => safety strip EDGE 2
NOTE: this output is enabled from the safety
strips stored in 4-5-6 positions
Gray wire => contact common COM
Yellow wire => safety strip EDGE 1
NOTE: this output is enabled from the safety
strips stored in 1-2-3 positions
Black wire => photocell PHOT N.C.
White wire => terminal for connecting the wire coming from the
system control button N.O.
Brown wire => auto test power feed A-D+ TEST.
J2 => CONNECTOR FOR CONNECTIONS TO THE 12/24V ac/
dc CONTROL PANEL AT THE BLINKER OUTPUT (CHECK
POLARITY)
Red wire => positive (connects to the positive pole of the blinker
output)
Black wire => negative (connects to the negative pole of the
blinker output)
J4 => TERMINALS FOR CONNECTIONS TO THE 120/230V
CONTROL PANEL, AT THE BLINKER OUTPUT
J5 => TERMINAL BOARD FOR CONNECTIONS TO OTHER BRANDS
OR RIB CRX CONTROL PANELS
J8 => TERMINAL FOR CONNECTION TO THE ANTENNA 868,3 MHz
JP1 => A/D+ TEST
- Jumper selection AUTOTEST mode for control panels with
AUTOTEST negative power feed
+/~ Jumper selection AUTOTEST mode for control panels with
AUTOTEST positive/alternate power feed (as RIB control panels)
JP2 => Radio-control code removal for total opening
S1
2 1 6 5 4 3 2 1
1 central antenna 433 MHz
2 ground-plane antenna 433 MHz
3 negative power feed 12/24V ac/dc
4 positive power feed 12/24V ac/dc
5-6 connects at the total open/close input command in the control panel
20 20
20 20
SW1 JP1 JP2
J5
+ -
SW1 => Micro-switches for pairing and identifying strips and
photocells
S1 => PROG. RX Programming button
BUZZER => Sound signal for installation, warning and alarm status
LED
DL1 (red) - strip contact N.C. (EDGE 2)
DL2 (red) - strip contact N.C. (EDGE 1)
DL3 (red) - photocell contact N.C. (PHOTO)
DL4 (red) - total opening command with push-button N.O. in the
system
DL5 (green) - activated total opening radio-control.
DL6 (yellow) - electrical power indicator 12-24V ac/dc
DL7 (dual-color) - radio code learning for total and blinker opening
DUAL-COLOR LED EDGE PHOT
off => operating normally
green => strip sensor or photocell engaged
red/green => alarm
LED EDGE PHOT 1 - EDGE SENSOR OR PHOTOCELL 1
LED EDGE PHOT 2 - EDGE SENSOR OR PHOTOCELL 2
LED EDGE PHOT 3 - EDGE SENSOR OR PHOTOCELL 3
LED EDGE PHOT 4 - EDGE SENSOR OR PHOTOCELL 4
LED EDGE PHOT 5 - EDGE SENSOR OR PHOTOCELL 5
LED EDGE PHOT 6 - EDGE SENSOR OR PHOTOCELL 6
SW1 MICRO-SWITCHES - DIP
DIP 1 ON => STRIP SENSOR OR PHOTOCELL 1 ACTIVATED
DIP 2 ON => STRIP SENSOR OR PHOTOCELL 2 ACTIVATED
DIP 3 ON => STRIP SENSOR OR PHOTOCELL 3 ACTIVATED
Dual-color Led
EDGE PHOT 1-6
J4
J2
12/24V ac/dc