Waste Disposal - Beninca MS5 Manual De Instrucciones

Manually open the gate and leave a clearance from 1 to 3cm according to the weight of the gate between the main door and the mecha-
nical stopper A. Fix the bracket to the limit switch S by using the grains G, so that the limit switch microswitch F is pressed. The same
operation should be repeated with gate in the closing phase.
N.B.: The limit switch bracket should be positioned so that the gate can be stopped without hitting the mechanical stopper.
Should a power failure or malfunction occurs, to manually operate the gate proceed as follows:
- After inserting the customised key C, turn it anti-clockwise and pull the lever L.
- The gear motor is unlocked and the gate can be moved by hand.
- To return to the normal operating mode, close the lever L again and manually activate the gate until it is geared.
For the wire connections of the system and to adjust the operating modes, please refer to the Instruction Manual of the control unit.
In particular, the anti-crash device (encoder) should be adjusted according to regulations in force.
Please remember that the device should be earthed by means of the appropriate terminal.
Fig.10 shows wiring for a standard installation. Before proceeding to wiring, check that the type of cables used is consistent with those
required for accessories.
Dimension H stands for the installation height of photocells. A clearance between 40 and 60 cm is advisable.
Key of components:
1 Gear motor with incorporated MS5 control unit
2 M4 rack, Nylon/Fe
3 Limit switch brackets
4 Photocells
5 Mechanical stoppers
6 Key selector or digital keyboard
7 Flashing light
8 Antenna
As indicated by the symbol shown, it is forbidden to dispose this product as normal urban waste as some parts might
be harmful for environment and human health, if they are disposed of incorrectly. Therefore, the device should be dis-
posed in special collection platforms or given back to the reseller if a new and similar device is purchased. An incorrect
disposal of the device will result in fines applied to the user, as provided for by regulations in force.
12
POSITIONING OF THE LIMIT SWITCH BRACKETS
FIG.12
MANUAL OPERATION
FIG.13
WIRE DIAGRAM
FIG.14

WASTE DISPOSAL