Indel B K SMART Instrucciones Para El Uso página 24

ENGLISH
INSTALLATION
To install the Minibar properly, you must ensure the air supply to the refrigerating unit making openings for
air inlet and outlet as shown on the following figure.
VENTILATION
The compressor cooling system lets out heat and needs good ventilation. Therefore places with bad venti-
lation are not very suitable. The Minibar must be installed in a place with an opening which guarantees
the necessary exchange of air, and it is of the utmost importance not to cover up or obstruct the grids
which provide the device with proper ventilation. One must also avoid positioning it in a place which
is directly exposed to sunlight or to other heat sources.
22
For the built-in models, you must fit the Minibar into the cabinet,
guaranteeing a cross section at the air inlet and outlet of at
least 200 cm , equal to a height of mm. 48 by the width of
2
the refrigerator. Leave 60 mm free between the Minibar and
the furniture on the top, left and right sides.
SERIE K ECOSMART
SRKECOSMART-01_15-01-2014