Luggie Smart Fold Manual De Instrucciones Para El Usuario página 14

2. Pull backward on the seat lock handle to adjust the height of the seat while
simultaneously lifting the seat. (FIG 3).
Note: Please make sure that the seat is properly locked and secured before sitting on the
Luggie. There are two windows on either side of the seat lock handle that will appear
red when the seat is locked and properly secured. Securing the seat adjustment will help
prevent accidents or tilting of the seat.
3. Fasten the chassis hooks or security locks on each side of the joint of front and
rear chassis (FIG 4)
4. Release the tiller locking clamp (FIG 5).
5. Pull the trigger outward to raise the tiller to a comfortable position (FIG 6).
6.
7. Refer to the Quick Start Guide to install your battery. Slide the battery against the
inside edge of the battery compartment before pressing it into place.
Warning: If the installed Luggie battery has been idle for a long period, the
battery may be in a low power state.
Warning: The best practice is to remove the battery when transporting the
scooter so as not to accidently power on the scooter which cause injuries and drain
the battery.
Warning: Armrest Installation (optional): If your purchase comes with armrests, refer
to the Luggie Armrest Installation Guide included with your scooter order. Insert and screw
the adjustment knobs on the bottom side of the back of the seat assembly.
Note : The knobs DO NOT need to be screwed on too tightly. These knobs are pull-pin
knobs for you to adjust the width of the armrests.
Caution: The backrest of your seat will not fully fold forwards if the armrests are
positioned too closely towards one another.
Warning: When the scooter is in operation, the armrests should not be in the
raised position.
9
FIG 3
FIG 5
.
FIG 4
FIG 6