Basic Fault Finding - Luggie Smart Fold Manual De Instrucciones Para El Usuario

All steering components
Clean chassis and repaint any exposed parts.
Replace any damaged axle seals.
Cycle charge for full operation function.
Cycle test batteries for operating capacity. (Ask your Authorized Luggie Dealer for
details.)
Note: Annual inspection will include weekly, semi-annual and annual checks listed above.
LUBRICATION
Use a general purpose noncorrosive lubricating fluid (i.e. WD-40) on moving parts. All
wheel bearings are factory sealed and should not normally need lubricating. Handlebar
bearings should be lubricated with a general purpose bearing grease. Your drive axle is
Caution: DO NOT mix other lubricants with this factory fitted drive axle lubricant.
Failure to observe this caution will invalidate your warranty.
Note: Service interval recommendations are guidelines for proper care and maintenance of
your scooter. More frequent use of your scooter may require more frequent adjustments to
these suggested intervals listed above.
Q: What if my Luggie will not start?
A: Check to see whether the power switch has been switched 'on'. If it is, the
battery indicator meter will be operating. If the status light on your top console
is flashing once per second, your battery is low in charge. Charge your
battery.
Q: What if the status light on the power switch fail to operate when the switch
is in the 'on' position?
A: Make sure the charger is not plugged into the charge socket of your scooter. When
your scooter being charged, you will not be able to drive.
Q: What if my Luggie stops for no apparent reason?
A: Your battery may not be working properly. Contact your Authorized Luggie
Reseller.
35

BASIC FAULT FINDING