Important - Luggie Smart Fold Manual De Instrucciones Para El Usuario

TIRE SERVICING REAR WHEELS
To remove a rear wheel from your Luggie follow the instructions below (ONLY
COMPETENT PEOPLE SHOULD CARRY OUT THESE PROCEDURES).
Power off your Luggie.
Using a suitable body stand, lift the side of the vehicle you wish to service off the
ground. Place the stand under the chassis. Care must be taken when lifting heavy
loads. You may need a friend to help you. Please be safe. DO NOT lift the scooter
by the plastic body work.
With the aid of a 13mm spanner (not supplied), remove the center hub nut
and washer.
Slide the wheel from the mounting axle. Rear wheels are fitted to the drive axle via
a hub which is located onto a key. These wheels fit tight onto the axle and may
need some pressure on the wheel hub to release them from the axles. Look for
spacing washers and take care not to misplace the drive key which fits between the
wheel hub and the axle shaft.
To reassemble the wheel simply follow the above procedure in reverse order
noting the following points:
Make certain that you replace any spacing washers and keys in the order that they
were moved.
Locking Screws: The special 'locking' center hub screws may lose its effectiveness
when it has been removed over a number of times. New screws should be used
each time the wheel is removed. Contact your Authorized Luggie Reseller to
purchase parts or have the tires replaced.
TIRE SERVICING FRONT WHEELS
be changed out when the tread have been worn out or cracked due to weather. Remove
the wheel from the fork or turning axle shaft with the aid of 19mm and 21mm spanners
(tools are not included). The front wheel has two bearings which may have various spacing
washers between the forks. Please note the order of these washers. Remove the tire from
the wheel by following steps above for rear wheels, using a 10mm spanner and 4mm hex
key. Reassembly in the reverse procedure making certain that all washers supplied are
replaced in the correct order removed.
BATTERY
Keep your battery well charged (see Battery Charging section of this manual). Keep battery
clean and store in dry frost-proof location. Your Luggie Dealer will be able to test your
battery for its condition.
Note : Service charge may apply for this service.
IMPORTANT: It is not possible to predict the life expectancy of your battery. This is
mainly due to the different workloads a battery can be subjected to during your day to
day use. The life of your battery will be dependent on the following: motor loads, general
service factors, care and maintenance working conditions, periods of nonuse and abuse etc.
When you ready to replace your Luggie battery, ALWAYS order the battery made for your
33