Luggie Smart Fold Manual De Instrucciones Para El Usuario página 15

TILLER ADJUSTMENTS
1. The tiller of your Luggie is designed to allow you to position the handlebars in
a comfortable driving position. It can be locked into numerous positions for your
comfort and ease of transport.
2. To adjust the angle of the tiller (angle the handlebars), locate the trigger as
pictured in (FIG 6). Pull the black lever (trigger), outward to adjust the angle of the
tiller. To lock the tiller in your desired position, simply release the trigger or the
black lever.
HANDLEBAR ADJUSTMENTS
1. The handlebars of your Luggie is designed to adjust in width for added
comfort when driving.
2. To adjust the handlebars of your Luggie simply pull the grips outward on
either ends, turn forward and let go to lock.
3. To re-adjust the handlebars to its shorten position reverse the steps above.
Warning: ALWAYS retract the handlebars (shorten position) before folding the
tiller down to the locking clamp.
Warning: ALWAYS make certain the trigger or black lever on the tiller is fully
down in a locked position and the tiller height is securely locked in place before
driving your scooter. To make service adjustment to these parts, refer to the Care and
Maintenance section of this manual (page 31-35).
Caution: DO NOT power off the Luggie when your scooter is moving. Failure to
observe this warning will result in sudden braking of the motor brake and place you in
a dangerous situation. You should ONLY power off your scooter while in motion in
the case of an emergency. Continual use of powering off to stop may cause undue
stress to the drive system and damage the main electronics. Be extremely cautious
on slopes. Sitting upright in your seat allows for greatest stability on your scooter.
The controls of your scooter are located on the top console in front of the handlebars when
seated on the Luggie.
1. Status Light: The power switch on your Luggie doubles as the status light indicator.
When the Luggie is powered "on", the light on the switch will be illuminated
as a solid for the entire duration of the "on" state. When your battery run low in
power, the status light will flash slowly at one flash per second. This is the
scooter's way of telling you that it is low in fuel and a charge is needed. If you
notice the status light flashing at two flashes per second, you are being
notified that the battery voltage is too low to drive. You must stop using your
scooter at the earliest opportunity when this happens. There is a total of nine
FIG 7 FIG 8
FIG 9
10