Dismounting - Abicor Binzel ABIDRIVE CW Instructivo De Servicio

TIG cold wire feeder

10 Dismounting

Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
Risk of crushing
Upper limbs can become crushed or caught at the covering hood.
• Do not reach into the danger zone.
• Wear protective gloves.
NOTICE
• Dismounting may only be carried out by qualified personnel (in Germany see TRBS 1203).
• Observe the operating instructions of the welding components and welding torch.
• Observe the information given in the following chapter:
Dismount the ABIDRIVE CW using the following procedure:
1 Dismount intermediate cable assembly.
2 Dismount cable assembly along with cold wire feed.
DANGER
WARNING
 7 Putting out of operation on page EN-15.
10 Dismounting
EN - 17