Connecting The Control Lead En; Mains Connection En; Electric Shock - Abicor Binzel ABIDRIVE CW Instructivo De Servicio

TIG cold wire feeder
5.5 Connecting the control lead
 Fig. 4 Overview of connections and operating elements on page EN-9
Carry out the following activities:
1 Connect the control lead (torch side) to connection X1.
2 Connect the control line (intermediate cable assembly) to plug X3 (5) .
This completes the connection of the control lines.
5.6 Mains connection

Electric shock

Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• For the mains voltage and the fuse protection, please refer to the technical data or the nameplate.
 Fig. 4 Overview of connections and operating elements on page EN-9
1 Insert plug socket (3) into connection X2 (4) .
2 Plug in mains plug (16) .
The ABIDRIVE CW is ready for operation.
DANGER
 3.4 Nameplate on page EN-7
 3.4 Nameplate on page EN-7
5 Putting into operation
EN - 11