Troubleshooting - Abicor Binzel ABIDRIVE CW Instructivo De Servicio

Alimentador de alambre en frío tig
Ocultar thumbs Ver también para ABIDRIVE CW:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9 Troubleshooting

9 Troubleshooting
Risk of injury and machine damage when handled by unauthorized persons
Incorrect repair work and changes of the product may lead to significant injuries and machine damage.
The product warranty will be rendered invalid if the unit is handled by unauthorized persons.
• Operating, maintenance, cleaning and repair work may only be carried out by qualified personnel
Please observe the attached document Warranty. Please consult your dealer or the manufacturer in case of
doubt and problems.
NOTICE
• Please also consult the operating instructions for the welding components, such as the power source,
The following faults may occur during operation:
Fault
ABIDRIVE CW is not ready
for operation.
Wire is not fed.
No welding arc.
Torch body or power source
overheating.
Tab. 7
EN - 16
DANGER
(in Germany see TRBS 1203).
welding torch system, re-circulating cooling unit, etc.
Cause
• Main switch is switched off
• Mains connection interrupted
• Motor is defective
• Fault of the motor control card
• Power supply to the workpiece
• Power source or control system
• Control lead interrupted
• Insufficient flow of coolant
• Welding current too high
• Coolant hose or liquid-cooled
• Tungsten electrode loose
Troubleshooting
or torch interrupted
defective
power cable constricted or
closed
TIG cold wire feeder
Solution
• Switch on ABIDRIVE CW
• Establish mains connection
• Switch unit to currentless state,
replace motor
• Replace motor control card
• Close the power circuit
• Repair
• Replace
• Check the proper function and
performance of the coolant
recirculator
• Reduce
• Check the flow and replace if
necessary
• Tighten with the torch cap

Publicidad

Tabla de contenido
loading

Tabla de contenido