Putting Out Of Operation; Maintenance And Cleaning; Weekly; Daily - Abicor Binzel ABIDRIVE CW Instructivo De Servicio

TIG cold wire feeder

7 Putting out of operation

NOTICE
• Please make sure that the shutdown procedures for all components mounted in the welding system are
 Fig. 4 Overview of connections and operating elements on page EN-9
1 Switch off the (17) power switch.
2 Close the valve of the shielding gas cylinder.

8 Maintenance and cleaning

Scheduled maintenance and cleaning is a prerequisite for a long life and a trouble-free operation.
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• The maintenance intervals given are standard values and refer to single-shift operation.
• Maintenance and cleaning work may only be carried out by qualified personnel (in Germany see
• Check the coolant hoses, seals and connections for signs of damage and leaks, if necessary replace.
• Always wear your personal protective equipment when performing maintenance and cleaning work.

8.1 Weekly

The parts of of the ABIDRIVE CW listed below are subject to wear and soiling. This is why these parts must
be subjected to weekly maintenance and cleaning.
Oil all mobile parts and roller bearings with suitable lubricating oil.

8.2 Daily

Check the toothed wheels for abrasion and damage.
strictly observed before putting out of operation begins.
DANGER
DANGER
TRBS 1203).
7 Putting out of operation
EN - 15