Programming Coffee Doses; Programming Hot Water; Programming Standard Doses - Nuova Simonelli APPIA II V 2GR Manual Del Usuario

7.
PROGRAMMING Appia V
7.1
PROGRAMMING DOSES
To access the programming units, proceed as
follows:
NOTE: the procedure can be carried out with
the machine on.
To enter into the dosing programme press
the dispensing key continuously
for 5 seconds.
The delivery keys will begin to flash.
7.2
PROGRAMMING COFFEE
DOSES
To programme the amount of water for each of
the delivery keys, proceed as follows:
fill the filter holder with the right amount of
coffee (the double or single filter holder can
be used, according to the key to be pro-
grammed).
Place the filter holder in the group.
Press one of the delivery keys:
The machine will begin to dispense and
once the required quantity has been deliv-
ered, press the continued key
36
Delivery will cease and the selected dose
key will switch off (the other keys will con-
tinue to flash).
Press the continued key
programming function or to continue pro-
gramming other dose keys.
7.3
PROGRAMMING HOT
WATER
Use the relevant procedure to enter the
programming function.
Press the hot water selection key
Hot water delivery will begin.
Decide the required amount of hot water
and then press the key
Press the continued key
programming function or to continue pro-
gramming other selection keys.
7.4
PROGRAMMING THE
AUTOSTEAM STEAM
NOZZLE (OPTIONAL)
Use the relevant procedure to enter the
programming function.
Insert a jug containing milk and press the
steam key ; this will make steam
come out of the nozzle.
.
When the steam key
the control unit will store the sample tempera-
ture reached in its memory (if the milk tem-
perature reaches the maximum temperature,
steam delivery will be stopped and the maxi-
mum value will remain the setting for the
control unit).
to exit the
Press the continued key
programming function or to continue pro-
gramming other selection keys.
7.5
It is possible to enter pre-set values for the
.
4 group doses and water (steam).
To do this, it is necessary to press the key
again.
onds until the flashing keys switch off.
to exit the
The doses are:
1CN
40 cc
NOTE: A time setting of 0 seconds for steam
and water means this function will work
continually.
is pressed again,
to exit the
PROGRAMMING
STANDARD DOSES
and hold it down for at least 10 sec-
2CN 1CL 2CL
60 cc 50 cc 85 cc
WATER STEAM TEMP
0 sec. 50° C