MEGABRAS MD-5060x Guia Del Usuario página 18

12. Then, the display will show the test number, the selected voltage value and it
will start the elapsed time count. If the measured value is within the device
scope, the test number indication will provide place for the resistance value in-
dication and its corresponding unit, and it will start the analog bar-graph indi-
cation.
13. If, for example, the measured value is 601 MΩ with a selected voltage of
1000 V the display will initially remain on during a few seconds, as it is shown
below, informing that test 12 was started.
14. After a few seconds, in the same example, the display will indicate that the
measured resistance value is 601 MΩ, as it is shown:
15. If the measured value exceeds 5000 GΩ @ 5 kV, the following message will
be read:
20