Lift the wheels one after the other and spin them.
The wheels must spin smoothly.
The tires must not rub against the frame.
Check the tire pressure.
The tire pressure should be about 2 bar. The maximum tire pressure of the wheel and of the tire used must not be exceeded.
Check the tightening torque of the thru axles.
The thru axle of the rear wheel must be tightened to 12 Nm!
COMPONENTS
It should not be possible to turn the handlebar with normal force.
No bearing play must be detectable.
Make sure that all components are tight.
FRAME
Check the frame for damages and deformation.
There must be no damages.
FORK /
SHOCK
We recommend a SAG of 15% - 20% on the fork and 20% - 30% on the shock.
your weight. Details can be found in the user manual of your bike.
BRAKES
The front and rear wheel must lock when the brake lever is pulled.
Break in the brake pads. Choose a road away from public roads and brake 20 to 30 times with the front or rear brake from a speed of 30 km/h down to 5 km/h. You should brake as
hard as possible without locking one of the wheels. Repeat the process for the other brake. Only then the brake can show its full braking power.