Accessories (Optional) - Nice O-Box Instrucciones Y Advertencias Para El Uso

a) – on O-BoxB, press and hold the Activity key and wait for these phases to
be completed: O-BoxB emits a beep and the led turns off; the led lights up
again and O-BoxB emits a series of beeps.
b) – At this point the data stored in the O-BoxB memory have been deleted and
the Activity key can be released.
2.2 – ACCESSORIES (optional)
Note – O-Box is only supplied with the USB cable; all other cables are optional
and are not supplied in the pack. These cables are:
– Cable mod. CABLA06 for connector D, in fig. 2: used to connect receivers in
the series "SMX" and "NiceOne".
– Cable mod. CABLA02 for connector M, in fig. 2: used to receive codes of
transmitters in the series "Bio".
– Serial 9-pin cable, RS232, mod. CABLA01 for connector G, in fig. 2: used to
connect O-Box to a computer.
– TTBUS Cable mod. CABLA05 for connector H, in fig. 2: used to connect all
Nice tubular motors for sun awnings and shutters, equipped with TTBUS
port.
– Cable mod. CABLA03 for connector I, in fig. 2: used to connect transmitters
in the series "Very".
– Cable mod. CABLA02 for connector I, in fig. 2: used to connect transmitters
in the series "Bio" and "FloR".
– Cable mod. CABLA04 for connector I, in fig. 2: used to connect transmitters
in the series "Ergo" and "Plano".
– Power supply unit mod. ALA1, 12 V, 300 mA for connector E, in fig. 2: used
to connect O-Box to the electrical mains.
2.3 – CONNECTORS AND DEVICES COMPATIBLE WITH O-BOX
O-Box has various types of connectors (see fig. 2) to enable the connection of
a wide range of Nice devices. Note – Some of these connectors require a spe-
cific connection cable: for the model and characteristics of each cable, see
paragraph 2.2.
With reference to the letters in fig. 2 identifying the connectors and other
devices of O-Box, the following provides a detailed description of the relative
functions and use:
[A] – O-Box on/off key
To turn on O-Box press and hold the ON key for a few seconds until a brief
beep is emitted.
To turn off O-Box press and hold the ON key for a few seconds until a long
beep is emitted.
[B] – Area for connection via radio of transmitters in the series
"NiceOne"
This area enables programming via radio, i.e. without any physical connection,
of all transmitters in the Nice series "NiceOne": transmitters are programmed by
placing them on the area outlined by the graphic sign.
During use of the software, the transmitter led emits a flash to indicate activa-
tion of communication via radio with the software. At this point the user can
start working with the software on the transmitter parameters (see chapter 3
paragraph 3.3).
2
E F G
A B C
H I L M
D
English – 3