Prior To Use; Installation - Sears Kenmore Elite 795.7303 Serie Manual Del Usuario

REFRIGERATOR INSTALLATION

PRIOR TO USE

1. Clean your refrigerator thoroughly and wipe off all
dust that accumulated during shipping.
2. Install accessories such as ice cube bin, drawers,
shelves, etc., in their proper places. They are packed
together to prevent possible damage during shipment.
3. Allow your refrigerator to run for at least two to three
hours before putting food in it. Check the fl ow of
cold air in the freezer compartment to ensure proper
cooling. Your refrigerator is now ready for use.

INSTALLATION

The refrigerator should always be plugged into its own
individual properly grounded electrical outlet rated for
115 Volts, 60 Hz, AC only, and fused at 15 or 20 amperes.
This provides the best performance and also prevents
overloading house wiring circuits which could cause a fi re
hazard from overheated wires. It is recommended that a
separate circuit serving only this appliance be provided.
WARNING
Shock Hazard:
To reduce the risk of electric shock, do not install the
refrigerator in a wet or damp area.
NOTE:
This appliance is intended to be used in household and
similar applications such as:
• staff kitchen areas in shops, offi ces and other working
environments
• farm houses and by clients in hotels, motels and other
residential environments
• bed and breakfast environments
• catering and similar non-retail applications.
This product is not to be used for special purposes such
as the storage of medicine or test materials, or for use
on ships, etc.
INSTALLATION (continued)
1. To avoid noise and vibration, the unit must be
leveled and installed on a solidly constructed fl oor. If
required, adjust the leveling legs to compensate for
unevenness of the fl oor. The front should be slightly
higher than the rear to aid in door closing. Leveling
legs can be turned easily by tipping the cabinet
slightly. Turn the leveling legs clockwise to raise the unit
or counterclockwise to lower it. (See LEVELING AND
DOOR ALIGNMENT.)
NOTE: Installing on carpeting, soft tile surfaces,
a platform or weakly supported structure is not
recommended.
2. Install this appliance in an area where the temperature
is between 55°F (13°C) and 110°F (43°C). If the
temperature around the appliance is too low or high,
cooling ability may be adversely aff ected.
3. Select a place where a water supply can be easily
connected for the automatic icemaker.
NOTE: The water pressure must be between 20 and
120 psi on models without a water fi lter and between
40 and 120 psi on models with a water fi lter.
4. Too small of a distance from adjacent items may
result in lowered freezing capability and increased
electricity consumption charges. Allow at least 24
inches (61 cm) in front of the refrigerator to open the
doors.
10
2" (5.08 cm)