Publicidad
Switching on / off
Switching on:
Press and hold button 5� Display 1 will
show some signs (see fig. 3, 14).
Switching on:
Press and hold button 9� Signs on
display 1 will disappear� Addition-
ally, the appliance automatically turns
off after 3 minutes of inactivity� Short
pressing of button 9 deletes the mea-
surement result�
Working advice
Presetting the appliance before
measurements (see fig. 5-12, 16-25)
[CT44028,
CT44029,
CT44031]
•
To select the reference point, press
and release button 8 (see fig. 5).
Sign 18 will display the selected refer-
ence point�
To
select
•
units, press and hold button 27 (see
fig. 6). The measurement units will
be alternately displayed on display 1
(sign 17)�
•
To select the measurement type,
press and release button 27 (see
fig. 7-9). The selected measurement
type is displayed with sign 14 (area or
volume measurement) or sign 15 (indi-
rect measurements)�
•
In the single measurement mode,
the obtained results can be added, sub-
tracted, stored in the appliance memory
using button 25 (see fig. 10-12).
[CT44032,
CT44033,
CT44035]
To select the reference point, press
•
and release button 8 (see fig. 16).
Sign 18 will display the selected refer-
ence point�
CT44030,
the
measurement
CT44034,
•
To
units, press and hold button 11 (see
fig. 17). The measurement units will
be alternately displayed on a display 1
(sign 17)�
To select the measurement type,
•
press and release button 6 (see
fig. 18-22). The selected measurement
type is displayed by sign 14 (area or
volume measurement) or sign 15 (indi-
rect measurements)�
•
In the single measurement mode,
the obtained results can be added,
subtracted, stored in the appliance
memory using buttons 7, 10 and 11
(see fig. 23-25).
Single measurement (see fig. 3, 14)
•
Turn on the appliance�
•
Set the appliance in the measure-
ment starting point�
Press and release button 5� Dis-
•
play 1 will show the measurement re-
sult (see fig. 3, 14).
Continuous
maximum
measurement (see fig. 4, 15)
•
Turn on the appliance�
•
Press and hold button 5, display 1
will show sign 13 (see fig. 4, 15).
•
Take measurements�
Display 1 will show measure-
•
ment results� The maximum and
minimum values will be indicated with
signs 19, 20�
Area measurement (see fig. 7, 18)
•
Turn on the appliance�
•
Press and release button 28 or 6
(depending on the model) to enter the
area measurement mode� Display 1 will
show sign 14 (see fig. 7, 18). There are
flickering symbols around sign 14; they
show which of the two distances should
be further measured�
•
Press and release button 5 to meas-
ure the length�
English
27
select
the
measurement
/
minimum
measurement
and
values
Publicidad
