SHERCO SE 4.5i-f Manual De Propietario página 63

AVE Function
Mean speed
This function determines your mean
speed.
A pressure of 3 sec on the button initia-
lizes the mean speed to 0.
Fig4 AVE function
LAP function
Automatic chronometer
This function describes the function/display
of the chronometer associated with theTD.
The figure displays the time lapse of the bike
(in mm:ss format if hours = 0, and in hh:mm
format if hours > 0), associated with the TD
parameter
It is therefore an automatic counter: It is
automatically activated with the first impulse
Fig5 LAP function from the speed sensor (when LAP is opera-
tive, the digit separating hours and minutes,
and minutes and seconds, flashes, and is
displayed fixed when LAP is not operative),
and stops 3 seconds after reception of the
last impulse sent by the speed sensor. The
data is not saved permanently to memory.
It is possible to zero the counter associa-
ted with this parameter by pressing the
button (below the LAP function) for about
3 seconds until the value 00'00" appears.
The zeroing of the LAP can be effected both
while stationary and whilst moving, and also
zeroes the TD function. If the figure exceeds
23-59 (that is 23 h 59 min and 59 sec), the
system will automatically zero the LAP and
TD, and will then restart the trip function.
MAX function
Maxi speed
This function shows the maximum
speed of the vehicle. A pressure of 3
sec on the button initializes the mean
Fig6 MAX function speed to 0.
61