SHERCO SE 4.5i-f Manual De Propietario página 67

1
2
3
Bike on side stand
Bike is on a horizontal surface
It is extremely important to follow these instructions carefully.
Incorrect coolant levels can cause serious damage to the engine.
COOLING
1. Radiator cap
2. Radiator bleed screw
3. Radiator
4. Cylinder head bleed screw
- Do not check when the engine is hot as
the hot liquid can cause severe injuries.
- Cooling liquid is poisonous:
- In the event of contact with the skin or
the eyes, or ingestion, or injuries cau-
sed by hot liquid:
CONSULT A DOCTOR
- Use protective gloves.
- Do not replace cooling liqid by water: It
could damage your bike engine .
- Always use pre-mixed coolant
With the engine cold check the cooling
fluid level and top up if necessary.
- Bike is on side stand (on left)
- unscrew bleed screws 2 and 4
- Adjust the level until liquid get out
without air by the screw 4
- Replace screw 4 tight at 6Nm
- Adjust the level until liquid get out
without air by the screw 2
- Replace screw 2 tight at 6Nm
- Take again the operation above for
control level
- Check that the cooling liquid level is
approximately 10mm above the radiator
tubes.
- Replace the cap 1 and make sure it is
seated correctly
WARNING
WARNING
65