Playcore Swing-N-Slide NE 5010 Instrucciones De Montaje página 31

Bottom Beam Clamp
(4) 1-1/4'' screws
1-1/4'' Wood Screw
Swing Hanger ssembly
1. Tap T-nut into 3/8'' hole as shown in Step 1.
2. Place a bottom beam clamp over the swing hanger as shown in Step 2.
3. Insert the swing hanger into the beam and thread it into the T-nut until it is flush or near flush with the top of the
T-nut. A screwdriver may be used to twist the hanger. Orient the Beam Clamp, making sure the slot is parallel
with beam length and the triangle of the Swing Hanger locks securely into the Beam Clamp slot, as shown in
Step 3.
4. Use (4) 1-1/4'' screws to secure beam clamp as shown in Step 4.
5. Check hanger to ensure it does not spin.
6. Repeat for all swing hangers.
Hammer
t-nut
T-nut
Swing Hanger
3/8'' hole
Use Screwdriver to aid in tightening
31
ProJect 512
Fig. 25
correct!