Publicidad
PROJECT 513
Fig. 22
T-nut
Washer
2-1/2'' screws
5-1/2 Hex Bolt
2-1/2'' screw
S. A-Frame Assembly cont.
1. 1. Tap T-nut into 3/8'' hole as shown in (Fig. 22)
Note: If using Laminated Swing Beam, make sure T-nut teeth do not fall between seams of 2'' x 6''s.
2. Attach A-Frame beam to Swing Beam using (2) 5-1/2'' hex bolts and 4 screws.
3. Tighten hex bolt to flush with top of T-nut. Repeat on other bracket.
33
Publicidad
