Jump Starting - Solar 4001 Manual Del Proprietário

OPERATING INSTRUCTIONS

Jump Starting

WARNING: DO NOT JUMP START WITH AC POWER CORD CONNECTED TO AC POWER
SOURCE. NEVER JUMP START A FROZEN BATTERY. A SPARK NEAR BATTERY MAY CAUSE
BATTERY EXPLOSION.
BATTERY 1 BATTERY 2
NOTE: Do not connect clamp to carburetor, fuel lines or sheet-metal body parts. Connect to a heavy gauge metal
part of the frame or engine block.
NOTE: If vehicle has 12 Volt system with dual batteries, connect to battery closest to starter.
5. Upon proper vehicle connection, green PROPER CONNECTION DETECTED LED will light.
NOTE: When jump starting severely depleted batteries, the PROPER CONNECTION DETECTED LED will not light
as under normal jump starting conditions.
a. For battery / battery bank voltage under 1VDC, the Voltage Error LED will light. See Step 6a for next steps.
b. For 12V systems with Voltage from 1-6VDC or 24V systems with Voltage from 1-15.4VDC, the Voltage Error
LED will light and the GOOD CONNECTION LED will flash. See Step 6b for next steps.
6. Depress Remote Switch to activate Boost Mode, Green BOOST MODE ENGAGED LED will light.
a. For Step 5a condition above, check all vehicle connections. Upon confirmation of proper vehicle connection,
depress Remote Switch for 10 seconds to override Reverse Connection Safety Feature (buzzer will beep once
per second).
b. For Step 5b condition above, check all connections. Upon confirmation of proper vehicle connection, depress
Remote Switch for 5 seconds to override Reverse Connection Safety Feature.
NOTE: Boost Mode engaged as long as switch is depressed. Boost duration can also be managed based on the
Timer setting. If longer Boost Mode is desired, adjust Timer.
7. Start the vehicle (turn on the vehicle ignition).
NOTE: If the vehicle doesn't start within 6 seconds, let the unit cool for 3 minutes before attempting to start the
vehicle again or you may damage the unit.
8. Once vehicle has started, adjust timer to minimum setting to turn off output.
9. When disconnecting unit from vehicle, ALWAYS disconnect the negative clamp from vehicle ground first. Always
remove positive clamp from battery terminal second.
10. When jump starting event is complete, disconnect output cables to prevent accidentally shorting the output.
1. Set selector cable to proper voltage of vehicle being jump-started and turn
unit on.
2. Position DC jumper cables to reduce risk of damage by hood, door or
moving engine part.
3. Stay clear of fan belts, pulleys and other parts that can cause injury to
persons.
4. Connect POSITIVE (RED) clamp from unit to POSITIVE (POS, P, +)
ungrounded post of battery. Connect NEGATIVE (BLACK) clamp to vehicle
ground (chassis or engine block away from battery).
12