FUEL CELL
INSERTING FUEL CELL
1. Press Up
2. Pull Out
Lift the fuel cartridge adaptor and insert the fuel
cartridge into the tool.
Release the adaptor so it is centered on the fuel
cartridge.
FUEL CELL
10
You complete the loading of Fuel Cell in the ST315i
tool by closing the Actuator Cover. You do this by
swinging it up and over the Fuel Cell Assembly and
pushing down until the Actuator Cover snaps into
position.
OUTDOOR WEATHER AND THE
ST 315i TOOL
Use the tool outdoors, in clear weather, When the
Tool, Fuel Cell, and Battery are between 20°F (-7°C)
and 120°F (49°C). Colder temperatures may damage
the Tool and Battery. Hotter temperatures may damage
the Tool and Fuel Cell. Fuel should be stored out of
direct sunlight in
surroundings less than 120°F (49°C).
After extended periods of continuous use, cool the
Tool by running
the Fan Motor.
Operation when the Tool is less than 20°F (-7°C) may
damage the tool . Fuel Cells at cold temperatures
lose the required propellant force. Bring the Tool,
Battery, and Fuel Cell above minimum operating
temperature without direct exposure to
check the Battery.
CAUTION
The ST315i tool should not be used in the rain or
where excessive moisture is present. These con-
ditions may result in damage to tool components
and cause tool to malfunction.
1. Swing Up
2. Push down
me, and