Preparing And Use Of The Impulse St-315I To O L - STOCKade IMPULSE ST-315i Manual Del Usuario

FASTENERS
The ST315i tool can drive only STOCK-ade
teners. Any other fastener will cause tool damage
and void your warranty.
LOADING FASTENERS
1. Pull the follower back on the rail of the maga-
zine until it locks in the rear position.
2. Insert the fence batten staples onto the maga-
zine rail.
3. Control the release of the follower and gently
allow it to move forward until it contacts the
staples.
4. You are now ready to start driving staples.
TOOL
OPERATION
Proper technique
assures smooth
operation of the tool.
Three easy steps to
actuated the tool are:
1. ENGAGE THE TOOL
PLACE the ST315i ADJUSTABLE NOSEPIECE
AGAINST WORK SURFACE. Then press down to
close tool.
Fan Motor will tur
Fuel is injected into the Combustion Chamber
and mixed with air by the Fan.
2. SQUEEZE THE TRIGGER The Spark Plug
sparks and fuel/air mixture ignites. Combustion
powers the Piston Assembly, driving the fastener.
3. RELEASE TRIGGER - LIFT THE TOOL
The Combustion Chamber opens. Fan exhausts
hot gases and cools internal components.
PREPARING AND USE OF ST315i TOOL
fas-
®
LED will be steady green.
PREPARING AND USE OF ST315i TOOL
NOTE: If no additional cycles are made, fan will
run for 7 seconds and then shut off.
TO PREVENT UNINTENTIONAL TOOL OPERATION,
AND POSSIBLE INJURY TO YOURSELF OR
ANYONE IN THE WORKING AREA, BE SURE
TO RELEASE THE TRIGGER AS SOON AS YOU
HAVE FINISHED DRIVING FASTENERS. NEVER
PRESS THE ADJUSTABLE NOSEPIECE AGAINST
ANY OBJECT EXCEPT THE MATERIAL TO BE
FASTENED.
DEPTH OF DRIVE
tool for depth of staple drive on waste timber
prior to commencing work.
Depress the work contact element and squeeze
the trigger. Note the depth of drive.
ADJUST THE DEPTH OF DRIVE
REMOVE BATTERY AND FUEL FROM THE TOOL
BEFORE MAKING ANY ADJUSTMENTS.
Loosen the adjustment socket headed cap screw
located near the tip of the work contacting element.
INCREASE THE DEPTH OF DRIVE
Slide the work contact element towards the body of
the tool to increase the depth of drive.
DECREASE THE DEPTH OF DRIVE
Slide the work contact element away from the body
of the tool to decrease the depth of drive.
11