An Overview Of The Impulse St-315I Tool - STOCKade IMPULSE ST-315i Manual Del Usuario

DESCRIPTION
The ST-315i tool is a self-contained, fully portable
tool that uses liquid hydrocarbon fuel to power a
a unique linear drive internal combustion motor.
In order for you to fully understand the information
contained in this manual, you need a basic under-
standing of the tool. As you can see in the illustration
below, the ST-315i tool is made up of three assem-
blies: the Handle, the Motor, and the Magazine.
As you examine the ST-315i tool, become familiar
with the three major assemblies and the various
components located in each of them.
The Handle Assembly contains the Fuel Cell, the
Battery Voltage Indicator Light, Battery and the
Trigger.
The Motor Assembly contains the Cover and Filter,
the Motor Housing, and the nose assembly.
The Magazine Assembly contains the Magazine,
follower assembly, and bracket.
AN OVERVIEW OF THE ST-315i TOOL
SPECIFICATIONS
Dimension:
Weight:
Cycle Rate: Intermittent Operation 2 to 3 staples per
second. Continuous Operation 1000 staples per hour.
NOTE: Exceeding these rates could cause the tool
to overheat, resulting in loss of performance or dam-
age to tool components.
By using the ST-315i tool at its recommended oper-
ation rate you will be able to drive several thousand
fasteners in a typical workday.
Maximum Fastener Length:
40mm
Magazine Capacity: 52 staples. (Two Strips)
Battery: 6 volts D.C.—Provides enough energy to
drive approximately 3000 fasteners on one charge . .
Fuel Cell: Liquid hydrocarbon—Provides enough
fuel to drive up to 1000 fasteners. .
AN OVERVIEW OF THE ST-315i TOOL
Height 15 inches / 381mm
Length 15 inches / 381mm
7.9 pounds / 3.6 kg
3