STOCKade IMPULSE ST-315i Manual Del Usuario página 15

SYMPTOM
Preparing Tool for Operation—Battery/Charger Problems
— Battery does not appear
to accept charge. Green
charger light does not
come on.
— Flashing lights on
charger base unit.
Normal Stage of Operation
— Fan does not run
—tool LED is off.
— Fan does not run, or
runs slower than normal
—tool LED is red.
Pre-Combustion/Combustion Stage of Operation
— Work Contact Element
does not depress fully
—tool does not operate.
— Tool will not cycle-fan
runs, LED is green.
POSSIBLE PROBLEMS
— Inoperative indicator
lights on charger.
— Battery damaged or
cycle life exhausted.
— Damaged charger.
— Damaged Battery
— Battery is not charged.
— Battery Terminals are
oily, dirty, or corroded.
— Battery is discharged.
— Staple Jammed or,
— Head or Sleeve Steel
Rings damaged.
— Fuel Cell is empty.
— Spark Wire out of spark
plug.
— Spark does not occur.
TROUBLESHOOTING
SERVICE
— Try Battery in tool after 3 hours on charge cycle .
If tool LED is green, charger lights are not working
properly. Replace charger, monitor charging time
to ensure Battery has adequate time for recharging.
It's normal for Battery to feel warm after properly
charging.
— Replace Battery.
— Discontinue use immediately and unplug from
power source. Replace charger and tag or dis-
pose of charger to prevent accidental reuse or
connection to power source.
— Replace Battery
— Charge Battery according to Operating Manual .
— Clean Battery terminals.
— Charge Battery.
— Clear Staple Jam.
STOCK-ade
— Contact Authorized
Representative for service.
— Replace Fuel Cell.
STOCK-ade
— Contact Authorized
Representative for service.
— Contact Authorized
Representative for service.
TROUBLESHOOTING
® Distributor Sales
Distributor Sales
®
STOCK-ade
Distributor Sales
®
15