Safety Instructions - STOCKade IMPULSE ST-315i Manual Del Usuario

SAFETY INSTRUCTIONS

The following safety instructions have been included
in this manual to provide you with basic information
necessary for safe operation of the ST-315i tool.
In addition to these instructions, additional training
may be necessary, depending upon the type of
fastening you wish to do. Contact your distributor
representative for additional information.
Do not attempt to operate this
tool until you have read and
understood all safety precautions
and manual instructions.
Failure to follow all safety precautions and instructions
may result in a permanent loss of vision, serious
personal or even fatal injury, property damage
and/or tool damage.
The ST-315i To o l is a n internal
combustion device. It produces
hot exhaust gases that may
ignite
This tool must not be used in a combustible
environment or in the presence of combustible
materials, such as
adhesives, gasoline, or solvents.
Do not expose the tool to
temperatures in excess of
120°F (49°C). Fuel and/or the
battery may burst, releasing
This tool must be operated only
in a well-ventilated environment,
because the tool exhausts carbon
monoxide similar to a gas chain
saw or lawnmower. Exposure to
carbon monoxide may cause dizziness, nausea,
or unconsciousness.
SAFETY INSTRUCTIONS
4
DANGER
mmable materials.
mmable chemicals,
mmable gas.
ALWAYS keep the ST-315i
Tool, fuel cell, battery and
battery charger out of the
reach of children.
1. READ THIS MANUAL FROM COVER TO COVER.
Always turn to this manual for information about
the safe operation and servicing of the ST-315i
tool. If any portion seems unclear, or you have
any questions, contact your Distributor Represnt-
ative immediately.
2. WEAR EYE AND HEARING PROTECTION.
Always wear hearing and eye
protection devices when you are
operating the ST-315i tool or
working in the vicinity of this tool.
Also, your eye protection must
meet the requirement of ANSI
Standard Z87, and should have side shields for
increased protection.
3. NEVER ASSUME THE TOOL IS EMPTY.
Every time you pick up the ST-315i tool, check the
Magazine for fasteners . Never point the tool at
anyone or yourself, even if you are absolutely sure
there are no fasteners in the tool. The fastener you
did not see is the fastener that can injure you or
someone else.
4. NEVER ENGAGE IN "HORSEPLAY" WITH THE
TOOL. The ST-315i tool is not a toy. . . it is
a power fastening tool. It is designed to drive a
a fastener into wood base material. To accomplish
this task, it generates a tremendous amount of
energy.
Fooling around, even when you are absolutely
sure there are no fasteners in the tool, is asking
for an accident.