Faucet Installation - KS RONDA N Manual De Instalación Y Funcionamiento

PRE-INStAllAtION INfO
chEcK cONtENtS
Separate all parts from the packaging and check each part with the pack
contents section. Pay attention to the variations of the different models.
Make sure all parts are accounted for before discarding any packaging
material.
If any parts are missing, do not attempt to install your electronic faucet until
you obtain the missing parts.
Min 300 mm.
Bottom of the washbasin
PREPARAtION fOR INStAllAtION
Flush the water supply lines thoroughly before installing the faucet. Do not
allow dirt, teflon tape or metal particles to enter the faucet. Shut off water
supply.
ImPORtANt
All plumbing is to be installed in accordance with applicable codes and
regulations.
Installations in Australia and New Zealand must comply with the requirements
of AS/NZS 3500.
4
WARNINg
1) To avoid reflection problems keep
a distance of more than 300 mm.
between the sink and the spout.
2) This faucet model, with an infrared
sensor pointing down, is not intended
to be used together with a sink of a
reflective material such as stainless
steel.
3) If a sink strainer is straight below the
faucet sensor, use a strainer with a non
reflective finish (do not use a chrome
plated one).

fAucEt INStAllAtION

StEP 1 – INStAllING thE fAucEt
1
Shut off the water supply.
Drill a hole (26 to 27 mm) where
you want to install the spout of
2
the faucet, and a small hole just
above the previous one for the
anti-rotation pin.
Remove the gasket, the disk, the
nut and the flexible pipe from the
base of the faucet and insert the
3
faucet through the wall.
Note: To remove flexible pipe
rotate counter clockwize.
Secure the rosette into position
4
using the anti rotation pin.
Fix the base behind the wall with
the hexagonal nut and the disk.
5 Reinstall the flexible pipe into the
base. Rotate the pipe clockwize.
RONDA N
26-27 mm
5