KS RONDA N Manual De Instalación Y Funcionamiento página 6

fAucEt INStAllAtION
StEP 1 – INStAllING thE fAucEt
1
Shut off the water supply.
Cut an adequate opening in the wall
according to the dimensions of the
2 mounting box, the cables sleeve,
the rigid pipe (not supplied) and the
faucet base with the support.
3
Dismantle the faucet base.
Drill two small holes for the faucet
4
base support and drive the anchors
in.
8
RONDA BOX
fAucEt INStAllAtION
Insert the mounting box through
the wall and connect the water
supply pipe (not supplied) to the
5
nipple at the bottom of the box
(make sure it is connected to the
water inlet).
Mount the faucet base with the
support through the wall opening,
and secure the base support to the
6
two small holes using 2 screws.
make sure that the base is leveled
to the center.
IMPORTANT: The faucet base should be
installed so that the outside surface of the
finished wall falls between the minimum
and maximum lines marked at the base.
Assemble the rigid pipe (not
7
supplied) from the nipple at the
box to the inlet at the faucet base.
RONDA BOX
RONDA BOX
mAX mIN
9