Numark Total Control Inicio Rápido página 8

CUE LE CONTROLLER OVERLAY
With Total Control, we have included a special edition of CUE LE so you can immediately begin DJing. Total Control's
controls are automatically mapped to the most important functions in CUE LE and we have provided a convenient overlay
for visual reference.
To install the CUE LE overlay, if not already installed on the unit:
1. Remove the fader caps by gently lifting them up from their base.
2. Gently pull out the existing overlay by lifting it from the top left corner. Put the existing overlay away for safekeeping.
3. Once the existing overlay has been removed, position the CUE LE overlay onto the Total Control.
4. Gently replace the fader caps.
Once you have installed the CUE LE software and overlay, please connect your controller and run CUE LE.
Please note: The Total Control must be connected to your computer before starting the software. Otherwise, the
software will not start.
Please refer to the controller mappings on the next page of this manual for additional information on how Total Control
controls are mapped to CUE LE.
CUE LE CONTROLLER MAPPING
1. TRACK – You can use this knob to scroll through the
different folders and tracks in Cue's browser. Press
down on the knob to expand subfolders.
browsing music inside a folder, you can always return
to browsing the folder structure by pressing the TRACK
knob again.
2. LOAD – Each virtual deck features a LOAD button.
The LOAD button has two functions:
When
Selecting a track and pressing the LOAD button
will load the track to the corresponding deck.
While using the TRACK knob to browse your
music in the folder structure, you can press
either LOAD button to enter the folder and
browse the music inside.
4