Connecting The Air Hose; Connecting The Ac Adapter; Wireless Function - A&D Medical PROCONNECT 651 Serie Manual De Instrucciones

Using the Monitor

Connecting the Air Hose

Insert the air connector plug into the
air socket firmly.

Connecting the AC Adapter

Insert the AC adapter plug into
the DC jack. Then, insert the AC
adapter into an electrical outlet.
The AC adapter part # TB-233, is
sold separately.
q Use the specified AC adapter. (Refer to E-22)
q When disconnecting the AC adapter from the electrical outlet,
grasp and pull the AC adapter body out of the outlet.
q When disconnecting the AC adapter plug from the blood pressure
monitor, grasp and pull the AC adapter plug our of the monitor.

Wireless Function

q In the unlikely event that this monitor causes radio wave
interference to a different wireless station, change the location
where this monitor is used or stop use immediately.
q Be sure to use in a location where visibility between the two
devices that you want to connect is good. The connection
distance is reduced by the structure of buildings or other
obstructions. In particular, connection may be impossible when
devices are used on either side of reinforced concrete.
q Do not use Bluetooth
LAN or other wireless devices, near devices that emit radio
waves such as microwaves, in locations where there are many
obstructions, or in other locations where signal strength is
weak. Doing so may result in frequent loss of connection, very
slow communication speeds and errors.
E-9
connection in the range of a wireless
®
Air Hose
Air Connector Plug
Air Socket
AC adapter Plug
DC Jack