Weinmann VENTI motion BiLevel ST WM 24800 Manual De Instrucciones página 31

Pressure setting
1. Wait approx. 1 minute, then read the CPAP pressure displayed or the IPAP and
EPAP pressures displayed in the bar chart and check whether the values display-
ed correspond to the prescribed values.
Triggering
Note
This check is not necessary when the the unit is operated in CPAP or T mode.
1. Switch off the unit by keeping the on / off switch
2. Fit the mask.
3. Switch on the unit by pressing the on / off switch
4. Put on the mask and breathe normally. In ST mode, your respiratory frequency
must be above the prescribed frequency at this point so that the unit's time-con-
trolled trigger is not activated.
The unit must react to the respiratory phase switch by switching pressure level .
Note
If the trigger for expiration does not function, it may have been switched off. Ask
your doctor whether this is the case.
Soft start:
Note
This test is not necessary if soft start has been locked out by the doctor.
Switch on soft start by pressing the soft start switch
The soft start indicator appears and the soft start time is displayed.
depressed for 2 seconds.
.
.
Function check EN 31