Inspection And Maintenance Plan; Decommissioning And Disposal; Important - Palazzetti MUTIFIRE IDRO NT Serie Uso Y Funciones

INSPECTION AND MAINTENANCE PLAN

Burn pot
Ash bin/Compartment
Glass
Door and burn pot gaskets*
Flue*
Fans*
Exchanger and fumes circuit*
responsibility of the Authorised Service Centre.
(*)
(a)
At least once a year or after each 4 tons of fuel burned
7 DECOMMISSIONING
AND DISPOSAL
Decommissioning and disposal of the stove
are the exclusive responsibility of the owner,
who must act in accordance with the laws in
force in the country where the stove is installed
with regards to safety and environmental
protection.
The stove may also be dismantled and
disposed of by companies authorised to
recover and dispose of the materials in
question.
INSTRUCTION: always observe the standards
in force in the country where the stove is
decommissioned as regards disposal of the
materials and the waste disposal report where
required.
IMPORTANT: All dismantling operations for
decommissioning the stove must be performed
when the stove is off and disconnected from
the power supply.
• remove all electrical equipment;
• separate the batteries fitted on the
electronic boards;
• have the structure of the stove scrapped
by an authorised company;
IMPORTANT: Dumping the stove in accessible
areas represents a serious hazard to people
and animals.
Liability for any harm caused to people or
animals always lies with the owner.
When decommissioning the stove the ce
mark, this manual and other documents
relating to this stove must be destroyed.
36
WHENEVER
WEEKLY
STARTED
X
X
X
00 477 6120 - 20/03/2019
1 YEAR (a)
X
X
X
X
The picture of the bin crossed is labelled on
the equipment, and it means that when the
device is out of use it has to be kept separated
by other wastes.
On the basis of Article 13 by Legislative
Decree n°151 of 25th July 2005 actuation
of the European Directive 2002/96/CE of
23rd February 2003 on waste electrical
and electronic equipment. It is connected
to the policy and action which aim to the
prevention of waste electrical and electronic
equipment,named RAEE, and in addition,
the reuse, recycling and other forms of
recovery of such wastes so as to reduce the
disposal of waste. It also seeks to improve the
environmental performance of all operators
involved in the life cycle of electrical and
electronic equipment.