Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
User's guide
In order to enter the calibration parameter it is necessary to short the K2 jumper K2
of the main keyboard.
To set parameters press the
password), press
The display will show the !rst function,
Pressing the
key will cycle through the other functions.
Pressing
will allow you to set the function. It may be necessary to either use
or set a value using the
the
key to increment a digit, followed by the
the
key to leave a parameter unchanged.
For example when the display shows
This display will show
to skip to the next parameter,
After pressing the
the "ashing digit, then use the
the next digit and set it as needed.
When all digits have been set press the
will go back to the parameter just st, i.e.
needed or press the
Parameter setting table.
Function Sub function
42
Indicator
key during selfchecing, display whill show
,
,
to enter.
.
key to move the active digit and then using
press the
, press the
key to set the low limit, or press the
for setting the high limit.
key to set a limit, use the
key to increment the "ashing digit. Continue to
key to store the value. The display
key to return to weighing.
Set high limit, press
digit, press
to change value, press
clear data, press
Set high limit, press
digit, press
to change value, press
clear data, press
Set beep mode;
: no beep for check Weighing
: beep when weight between hi and low (OK)
: beep when weight out of hi-low range (NG)
key to enter the value. Use
key to begin.
and
keys to change
. Advanced to another prameter if
description
and
key to move active
key to sure.
and
key to move active
key to sure.
Model BR30
(ask
key to
key to
Publicidad
Tabla de contenido
