Publicidad
5.
Durante l'installazione del pannelli a muro si dovranno proteggere le superfici, rivestimenti, pareti e piastrelle.
6.
Evitare qualsiasi tipo di sporchizia, concretamente i resti dei lavori.
7.
Il pavimento sul quale devono rimanere i pannelli a muro deve essere pulito, senza grasso e asciutto.
8.
Allo scopo di assicurare la perfetta installazione, le fasi del lavoro dovranno venire realizzate rispettando i tempi.
4. REPAIR INSTRUCTIONS PANEL ACQUABELLA
It is possible to repair the colour of an AKRON panel of Acquabella if for some reason its surface had been damaged by improper use.
In these cases you can request a repair kit that should be required specifying correct texture and colour of the panel to repair . The kit
includes two components, A and B.
Procedure to repair a panel:
1.
Clean the surface of the panel very well. Use industrial alcohol or acetone diluted in water with a lint-free cloth. .
2.
The surface must be completely clean and dry
3.
Secure with masking tape or similar susceptible areas (tiles , screens , etc.)
4.
Open the can and the bottle.
5.
Put the coloured lacquer and catalyst on a small painter plastic bucket and mix .
6.
Use a little roller to paint 8 or 10 cm. good quality ,doing long strokes and always in the same direction , repeating if necessary. It
is important not release lint remains,
7.
Depending on the state of the area to restore , you may need to apply several hands of painting. Allow to dry between them at
least 40 minutes before applying the next coat
8.
Finally let dry 48 hours before removing the masking tape protection.
Caution: for your safety, use mask and gloves as you are working with chemicals
5. ADVICE
1.
Transporting the panel only inside the package , and avoid excessive loads . Do not support on an upright position.
2.
CONSTRUPLAS SL is not responsible for damage caused by improper storage or transport.
3.
The installation must be performed only by authorized health specialist technician.
4.
Always check before installing the panel .
5.
During installation of the panel should protect the surfaces of the shower tray, tiles, wall tiles.
6.
Avoid any kind of dirt, soiling specifically work rests .
7.
The walls where the replacement panel sits must be clean, dry and free from grease .
8.
In order to ensure proper installation phases of work shall be done within the working times .
4. ANWEISUNGEN FÜR DIE REPARATUR DER WANDVERKLEIDUNG
Im Schadensfall haben sie die Möglichkeit die Oberflächeunserer Wandverkleidung AKRON auszubessern. Bitten geben sie in diesem
Fall die Oberfläche, sowie die Farbe der Duschtasse an. Hierfür bieten wir ein Reparaturset an, bestehend aus zwei Komponenten A
und B.
Vorgehensweise:
1.
Grundreinigung der Oberfläche unter Verwendung eines sauberen Lappen mit Brennspiritus oder verdünnte
2.
Die Oberfläche der Wandverkleidung muss sauber und trocken sein.
3.
Angrenzende Wand und Bodenflächen sind anzukleben
4.
Behälter öffnen.
5.
Die vorgesehene Menge der beide komponenten A und B 1:1 vermischen.
image C
images A-B.
Azeton.
14
Publicidad
