TURBO SpRAY NOzzLE (FIG. 5)
CAUTION: Do not attempt to move the nozzle to
adjust pressure. The turbo nozzle is NOT adjustable.
The high pressure turbo nozzle (R) is intended for
maximum cleaning effect. Keep the spray wand a
minimum of 6–8 in (15–20 cm) away from the cleaning
surface at all times.
USING DETERGENT (FIG. 6–7)
NOTICE: Use only approved pressure washer cleaners. Do not use bleach,
chlorine, or any cleaners containing acids.
NOTICE : Fill and flush the detergent tank with clear water after use.
1.
Insert the spray wand (B) into the gun (A) by pushing firmly and simultaneously
twisting a 1/4 of a turn until locked into place.
2.
Remove the tank cap (Z) present on the back of the machine.
3.
Fill the tank (J) with suitable cleaning solution.
6
4.
Install low pressure (black) nozzle into quick connect fitting of spray wand, see
How To use Spray Wand paragraph in this section.
NOTE: Detergent will not siphon when the spray wand is equipped with the Yellow,
Green, or Turbo Nozzles. The Low Pressure BLACK Nozzle must be used to
dispense detergent
5.
Squeeze the trigger and the detergent will automatically be mixed with the
water and dispensed from the nozzle.
6.
When you have completed the use of detergent, Fill and flush the detergent
tank with clear water after use. See Storage for correct procedure.
7.
See Storage section in this manual for proper shutdown and storage
procedures
CLEANING TECHNIqUES
When cleaning with the pressure washer, some cleaning tasks can be solved with
water alone, but for most tasks it is advantageous to use a detergent. A detergent
ensures a quick soaking of the dirt allowing the high pressure water to penetrate
and remove the dirt more effectively.
AppLICATION OF DETERGENT
CAUTION: Avoid working on hot surfaces or in direct sunlight to minimize the
chance of the soap damaging painted surfaces.
CAUTION: Damage may occur to painted surface if soap is allowed to dry on
the surface. Wash and rinse a small section at a time.
A
b
12- ENG
5
7
z
R
j