Troubleshooting Guide - Simpson 13SIE-170 Manual De Instrucciones

date of retail purchase and is not transferable. This warranty excludes incidental/
consequential damages and failures due to misuse, abuse or normal wear and tear.
This warranty applies only to products used in consumer (home) applications. This
warranty does not apply to commercial or rental applications. This warranty gives
you specific rights, and you may also have other rights, which vary from state to
state.
OPERATIONAL
ISSuE
Detergent is
not dispensing
Detergent to
Water ratio
Circuit breaker
trips or fuse
blown in
fuse box
TROUBLE SHOOTING GUIDE
POSSIbLE SOLUTION
CAuSE
Detergent is Use only detergents, degreasers, waxes
not pressure and other cleaning solutions, that are
washer designed specifically for pressure washers.
approved Cleaners in this category will clearly state
on the label that they are meant for use in
pressure washers. Do NOT use any other
type of cleaning solution in your pressure
washer. Never use bleach, ammonia, any
type of acid, or hot water in your machine!
See How to use Spray Wand paragraph in the
Incorrect noz-
zle installed Operation Section.
NOTE: Chemicals and soaps will not
siphon if the black soap nozzle is
not installed on the spray wand.
Detergent Detergent suction assembly is malfunctioning,
tank is filling contact our customer service department.
up with water Contact our customer service department at
www.simpsoncleaning.com.
The pressure washer draws detergent
at a maximum 10:1 water to detergent
ratio. Most pressure washer detergents
are concentrated within this range. If you
feel you are using more detergent than is
required for the application, you can dilute
the detergent with regular tap water.
Circuit Verify that the circuit is rated at 15 amps or
overload greater. Ensure no other appliance is drawing
power from the same circuit (dedicated circuit).
Extension We do not recommend the use of extension
cord too long cords with your pressure washer. If you must
or wire gauge use an extension cord, verify that it meets
too small the minimum requirements listed in the
Extension Cord paragraph under the Power
Supply & Electrical Info in this manual.
Nozzle Clean the nozzle according to the instructions
provided in the Nozzle paragraph under
partially
blocked the Maintenance section of this manual.
18- ENG