Simpson 13SIE-170 Manual De Instrucciones página 6

8. Follow the maintenance instructions specified in the manual.
9. This product is provided with a Ground Fault Circuit Interrupter built into
the power cord plug. If replacement of the plug or cord is needed, use only
identical replacement parts.
10. Do not touch plug or outlet with wet hands.
11. Avoid accidental starts. Move switch on unit to OFF position before connecting
or disconnecting cord to electrical outlets.
12. Water spray must never be directed towards any electric wiring or directly
towards the pressure washer machine itself or fatal electric shock may occur.
13. Never carry your pressure washer by the cord. Do not pull on the cord to
disconnect from the outlet.
14. To prevent damage, the cord should not be crushed, placed next to sharp
objects or near a heat source.
15. Check power cords before using. Damaged cords can reduce performance of
pressure washer or cause a fatal electrical shock.
16. The narrow pin point stream is very powerful. It is not recommended for use on
painted surfaces, wood surfaces or items attached with an adhesive backing.
17. Keep operating area clear of all persons and ani mals.
18. Always use both hands when operating pressure washer to maintain complete
control of the wand.
19. Do not touch nozzle or water spray while operating. Never place hands in front
of nozzle.
20. Wear safety goggles while operating. Wear protective clothing and footwear to
protect against accidental spraying.
21. Disconnect power plug from the outlet when not in use and prior to the
detaching of the high pressure hose.
22. Never tie knots or kink the high pressure hose as da mage could result.
Inspect the high-pressure hose regularly. Replace the hose immediately if it
is damaged, worn or shows any signs of cracks, bubbles, pinholes, or other
leakage. Never grasp a high-pressure hose that is leaking or damaged.
23. Do not operate or store this product in temperatures below 40 °F (4 °C). Freeze
damage is not covered by the warranty.
24. Carefully observe all chemical instructions and warnings before using. Use
only approved pressure washer cleaners. Do not use bleach, chlorine, or any
cleaners containing acids. Always follow manufacturer's label recommendations
for proper use of cleaners. Always protect eyes, skin and respiratory system
from cleaners.
25. The pressure washer should not be used in areas where gas vapors may be
present. An electric spark could cause an explosion or fire.
26. To minimize the amount of water getting into the pressure washer, the unit
should be placed as far as possible from the cleaning site during operation.
27. To prevent accidental discharge, the spray gun should be secured by locking
the trigger when not in use.
28. To allow free air circulation, the pressure washer should NOT be covered
during operation.
29. Never touch, grasp or attempt to cover a pinhole or similar water leak on the
high-pressure hose. The stream of water IS under high pressure and WILL
penetrate skin.
6- ENG