Simpson 13SIE-170 Manual De Instrucciones página 16

4. Turn the machine OFF and squeeze the trigger to re lease the trapped pressure
inside of the machine.
5. Remove both the garden hose and high pressure hose from the unit.
6. Disconnect the wand from the gun.
7. Turn ON the machine and allow it to
run for 5 seconds. (This will clear
out most of the water trapped in the
pump).
8. Unplug machine .
9. Wrap high pressure hose and power
supply cord onto storage rack and
snap power supply cord into place
as shown.
10. Store the machine and accessories
in a dry,
environment. Do not store the
machine or accessories in a place
where the temperature could drop
below 40 °F (4 °C).
DANgER: Risk of fluid injection. When using replacement wands or guns
with this pressure washer, DO NOT use a wand and/or wand/gun combi-
nation that is shorter in length than what was provided with this pressure
washer as measured from the nozzle end of the wand to the gun trigger.
NOTICE: The use of any other accessory not recommended for use with this
tool could be hazardous. Use only accessories rated equal to or greater than
the rating of the pressure washer.
Model
Rated Pressure*
Rated Water Flow*
Electrical Requirements
Electrical Cord
High Pressure Hose
Minimum Amp Source
Presure of Inlet Water
Inlet Water
Soap Consumption Rate
* Rated Pressure and Rated Water Flow is within manufacturing tolerance of
(+/- 10%).
In a continued commitment to improve quality, the manufacturer reserves the right
to make component changes, design changes, or specification changes when
necessary and without notice.
climate controlled
ACCESSORIES
SpECIFICATIONS
15
13SIE-170
1700 psi
1.3 gpm
120V,
13 A, 60 Hz
35 ft. (10.67 m)
23 ft. (7.0 m)
15 A
20–100 psi
cold tap
10% max
16- ENG